Changing The Door Hinges - hanseatic SC-130RG Gebrauchsanleitung

Page EN-18

Changing the door hinges

Changing the door hinges
NOTICE
Risk of damage!
Improper handling of the appliance
may result in damage.
Do not tilt the appliance more than
■
45°.
Do not lay it on its side.
■
Depending on the spatial conditions, you can
change the direction of the door hinges on
your appliance.
To change the direction of the door hinges,
you will need a medium-sized cross-headed
screwdriver as well as a knife or something
similar in order to remove the bling plugs from
the threaded holes.
1. Pull the mains plug out of the socket.
2. Carefully pull the six blind plugs out of
the threaded holes. You can use a knife
or something similar to help you, but
be careful not to damage the housing's
painted surface. A strong thread is also
suitable.
3. Ensure that the glass door cannot slip
away and unscrew the six cross-headed
screws from the refrigerator's housing.
4. Turn the glass door 180°, position it on
the opposite side and screw it on tightly.
5. Insert the six blind plugs into the open
threaded holes on the right side.
6. Close the door and check whether the
door closes flat.
7. If necessary, correct the door's position
using the elongated holes in the hinges.