Set The Water Softener - Pelgrim GVW537RVS Benutzerinformation

70

Set the water softener

The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
The higher the content of these minerals and
salts, the harder your water is. Water hard-
ness is measured in equivalent scales, Ger-
man degrees (dH°), French degrees (°TH)
and mmol/l (millimol per litre - international
unit for the hardness of water).
Water hardness
°dH
51 - 70 91 - 125
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
Setting manually
The dishwasher is factory set at position
2.
1. Open the dishwasher door.
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position
1 or 2 (see chart).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
°TH mmol/l
9,1 - 12,5
76 - 90 7,6 - 9,0
65 - 75 6,5 - 7,5
51 - 64 5,1 - 6,4
40 - 50 4,0 - 5,0
33 - 39 3,3 - 3,9
26 - 32 2,6 - 3,2
19 - 25 1,9 - 2,5
7 - 18 0,7 - 1,8
< 7 < 0,7
The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.
The water softener must be set in two
ways: manually, using the water hard-
ness dial and electronically.
Adjusting the water hardness setting
manually
2
2
2
2
2
2
1
1
1
1
1. Press the on/off button. The appliance
must be in setting mode.
2. Press and keep pressed the programme
selection/cancel button until programme
light A flashes and programme light B
comes on with a fixed light. Wait until pro-
gramme light B goes off. The programme
light A goes on flashing and simultane-
ously the end of programme indicator
light starts flashing. Wait until programme
light B goes off. The programme light A
goes on flashing and simultaneously the
end of programme indicator light starts
flashing. This indicates that you have ac-
tivated the electronic setting function of
the water softener. The current level is in-
dicated by the number of flashes of the
end of programme indicator light and a
pause of a few seconds.
Examples:
5 flashes, pause, 5 flashes, pause, etc. =
level 5
6 flashes, pause, 6 flashes, pause, etc. =
level 6
Use of
electronically
level 10
level 9
level 8
level 7
level 6
level 5
level 4
level 3
level 2
level 1
salt
yes
yes
yes
yes
yes
yes
yes
yes
yes
no