First Use; Setting The Water Softener - Pelgrim GVW476RVS Anleitung

FIRST USE

Before using the dishwasher for the first time:
• Set the water hardness.
• Add 1 litre of water to the salt reservoir and then add 1.5 kg of dishwasher salt.
• Add rinse agent.
• Add detergent.

Setting the water softener

1. Open the door to switch on the appliance.
2. Press the Program button for more than 5 seconds to start the water softener set model
within 60 seconds after the appliance was switched on (the water softener and Rinse agent
warning lights will be on periodically when it get in the set model ).
3. Press the Program button to select the proper set according to your local environment, the
sets will change in the following sequence: H1->H2->H3->H4->H5->H6;
4. Press the Power button to end the set up model.
Water softener table
Adjust the salt consumption according to the table below:
Water hardness
ºClarke
0 - 6
7 - 14
15 - 21
22 - 28
29 - 42
43 - 69
The manufactory setting: H4 (EN 50242)
Your local water authority can inform you how hard your mains water is.
ºdH mmol/l
0 - 5 0 - 0,94
6 - 11 1,0 - 2,0
12 - 17 2,1 - 3,0
18 - 22 3,1 - 4,0
23 - 34 4,1 - 6,0
35 - 55 6,1 - 9,8
setting in Salt
display consumption
(grams/cycle)
H1 0
H2 9
H3 12
H4 20
H5 30
H6 60
EN 9