Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation and Operating Instructions
Service menu | 02 – Hw setting (Hardware)
50 -
Factory reset
01 -
Mode
Hw Setting
04 -
Fan calibration
05 -
Filter calibration
Hw setting
Digital input (15-16)
Select contact
fire input
logic for switching
Digital output RUN (7-8)
using motion sensor
N.Close
or fire contact
– Operating signal potential-free contact (15-16):
The logic of the connected potential-free contact can be set as follows:
– N. closed (normally closed)
– N. open (normally open)
– Hot water heater battery frost protection:
Behaviour of extract air fan for hot water heater battery frost protection
Selection: Extract air fan on/off when hot water frost protection triggered.
Service menu | 04 – Fan calibration
01 -
Mode
02 -
Hw Setting
Fan calibration
05 -
Filter calibration
08 -
AQS Sensor
Fan calibration
Fan calibration is not required for KWL Yoga ventilation units. However, the
maximum flow rate can be limited in this menu.
Decentralised ventilation unit – KWL
Select RUN
contact logic
Calibration
Start calibration
®
Yoga / KWL
Service menu | 05 – Filter calibration
02 -
04 -
08 -
09 -
The calibration must be carried out for the initial commissioning and after a
filter type change.
Service menu | 08 – AQS Sensor (air quality sensor)
04 -
05 -
09 -
10 -
Select air
quality
sensor
25
®
Yoga Style
Max. flow
Hw Setting
Fan calibration
Filter calibration
AQS Sensor
Temperature sensor
Fan calibration
Filter calibration
AQS Sensor
Temperature sensor
Supply Duct Limits
AQS Sensor
None
AQS Limits
Set the limit va-
lues for air quality
sensors
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
