Operation; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TE-CG 18 Li Originalbetriebsanleitung

•
Fit the rubber cap back on the nozzle

6. Operation

6.1 Operation (Fig. 6)
•
Check that a glue stick is fitted (see point 5.2)
•
Press the On/Off switch (1) briefly.
•
The LED (2) will light up red to indicate that
the equipment is heating up
•
This takes approx. 120 seconds, after which
the LED (2) will light up green.
•
The equipment is now ready for operation.
•
To switch the equipment off again, press the
ON/OFF briefly just the once
Warning!
Never set the equipment down once you have
started using it.
If or when your gluing work is interrupted or fi ni-
shed, always be sure to stand the equipment on
its rechargeable battery as shown in Fig. 4.
Switch the equipment off and allow it to cool down
completely before you pack it away.
6.2 Working with the cordless hot glue gun
•
You can now apply the glue by pressing the
trigger lever (4) after the heating up time
•
Press both surfaces together immediately
and apply pressure to them
•
It takes about 30 seconds for the glue to set
•
Always stand the cordless hot glue gun on its
rechargeable battery (Fig. 4).
The equipment switches off automatically after
approx. 5 minutes of non-use.
Important!
Glue stains on textiles cannot be removed.
6.3 LED light (Fig. 1/Item 8)
The LED light (8) will come on automatically as
soon as the equipment is switched on.
To switch off the LED light, press the On/Off
switch (1) for about 3 seconds when the equip-
ment is switched on. To switch the LED light on
again, repeat the procedure.
Anl_TE_CG_18_Li_Solo_SPK9.indb 17 Anl_TE_CG_18_Li_Solo_SPK9.indb 17
GB
6.4 Battery capacity indicator (Fig. 7/Item e)
Press the button for the battery capacity indicator
(d). The battery capacity indicator (e) will indicate
the charge status of the battery by means of 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED blinks:
The battery is empty, recharge the battery.
All LEDs blink:
The battery pack has undergone exhaustive di-
scharge and is defective. Do not use or charge a
defective battery pack.
7. Cleaning, maintenance and
ordering of spare parts
Warning!
Allow the equipment to cool down before you start
to clean it.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
- 17 -
03.05.2019 10:28:01 03.05.2019 10:28:01