Charging The Battery (With Wall Mounting); Wall Mounting; Attaching The Mounting Plate; Attaching The Charging Cable To The Wall Bracket - Miele Triflex HX1 SM Serie Gebrauchsanweisung

 Plug the supplied charging cable into
the charging socket on the bottom of
the battery.
 Plug the charger into a power socket.
The charging process will start.
You can read more about this in "Bat-
tery charging state indicator".
Charging the battery (with wall
mounting) (Fig. 12 + 13)
There are 2 ways to store and charge
the vacuum cleaner in the supplied wall
bracket.
You will need a suitable location near
a free power socket for mounting the
appliance on the wall.
Wall mounting (Fig. 14 + 15)
The supplied wall bracket has a mount-
ing plate with a bag of screws attached
to the back.
Attach the mounting plate to the point
on the wall where you want the wall
mounting to be.
 Remove the bag of screws.
 Press the release catch at the bottom
of the wall bracket.
 Remove the mounting plate from the
wall bracket by sliding it downwards.

Attaching the mounting plate

(Fig. 16 + 17)
2 plugs and 2 T20 TORX screws are
supplied for attaching the mounting
plate to the wall.
You will also need a battery-operated
screwdriver or a drill (with a drilling dia-
meter of 6 mm).
Depending on how your vacuum
cleaner is configured, select a distance
of 45 cm or 98 cm between the bottom
edge of the mounting plate and the
floor.
Be careful not to damage any cables
laid in the wall.
 Attach the mounting plate to the wall.
Attaching the charging cable to the
wall bracket (Fig. 18, 19 + 20)
A cable compartment is located on the
underside of the wall bracket.
 Press both release catches on the un-
derside of the wall bracket and re-
move the cable compartment cover.
 Plug the supplied charging cable into
the opening from above.
 Lay the charging cable in its guide.
 Refit the cover and close the cable
compartment.
Connecting the accessories holder
(if required) (Fig. 21)
An accessories holder is supplied for
storing the three-piece accessory set
(see "Using the accessories supplied").
 Push the accessories holder on to the
wall bracket as far as it will go.

Connecting the wall bracket

(Fig. 22 + 23)
 Slide the wall bracket down into the
mounting plate from above until it
audibly clicks into place.
en
47