Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Charging the battery (with wall
mounting) (Fig. 12 + 13)
There are 2 ways to store and charge
the vacuum cleaner in the supplied wall
bracket.
You will need a suitable location near
a free power socket for mounting the
appliance on the wall.
Wall mounting (Fig. 14 + 15)
The supplied wall bracket has a mount-
ing plate with a bag of screws attached
to the back.
Attach the mounting plate to the point
on the wall where you want the wall
mounting to be.
Remove the bag of screws.
Press the release catch at the bottom
of the wall bracket.
Remove the mounting plate from the
wall bracket by sliding it downwards.
Attaching the mounting plate
(Fig. 16 + 17)
2 plugs and 2 T20 TORX screws are
supplied for attaching the mounting
plate to the wall.
You will also need a battery-operated
screwdriver or a drill (with a drilling dia-
meter of 6 mm).
Depending on how your vacuum
cleaner is configured, select a distance
of 45 cm or 98 cm between the bottom
edge of the mounting plate and the
floor.
Be careful not to damage any cables
laid in the wall.
Attach the mounting plate to the wall.
Attaching the charging cable to the
wall bracket (Fig. 18, 19 + 20)
A cable compartment is located on the
underside of the wall bracket.
Press both release catches on the un-
derside of the wall bracket and re-
move the cable compartment cover.
Insert the supplied charging cable
into the opening from above.
Lay the charging cable in its guide.
Refit the cover and close the cable
compartment.
Then turn over the wall bracket.
Connecting the accessories holder
(if required) (Fig. 21)
An accessories holder is supplied for
storing the three-piece accessory set
(see "Using the accessories supplied").
Push the accessories holder on to the
wall bracket as far as it will go.
Connecting the wall bracket
(Fig. 22 + 23)
Slide the wall bracket down into the
mounting plate from above until it
audibly clicks into place.
en
47
Werbung
Kapitel
Inhaltsverzeichnis
