Setting To Work; Important Note - EINHELL Royal TMP 500-S NIRO Bedienungsanleitung

Anleitung TMP 500 08.11.2001 8:03 Uhr
GB

Setting to work

Maintenance guidelines
After having read these instructions This submersible pump is an
carefully, you can set your pump to approuved, maintenance-free high
work, reconsidering the following quality product, which is subject to
items: severe final controls.
G Check if the pump rests on the
We recommend, regular inspection
ground of the shaft. and maintenance to ensure long
G Check of pressure cord has
equipment life and uninterrupted
been attached properly . operation.
G Check if electrical connection is
230 V ~ 50 Hz. Important! Note!
G Check if socket is in good
G Remove the mains plug before
condition.
G Make sure that water and humi-
G In the event that the pump is
dity can never come to the
mains supply.
G Avoid pump running dry.
G In case of stationary installation,
Incidents – Causes – Remedies
Incidents Causes
Pumpe does not start – No mains supply
– Floater does not switch
No flow – Inlet sieve is clogged
– Pressure hose in bent
Pump does not switch off – Floater cannot sink down
Insufficient flow – Inlet sieve is clogged
– Reduced pumping capacity by
Pump switches of after short – Thermal cutout stops pumps
operating period
– Water too hot. Thermal-cutout
6
Seite 6
G All fibrous particles which may
have built-up inside the pump
housing should be removed with
a water jet.
G In case of exessive deposits in
the pump casing, remove the
suction filter by releasing the 2
recessed head screws. Clean
the pump case and refit the filter.
G Every 3 months the shaft
ground and as should be
cleaned from mud.
G Remove deposits on the floater
all maintenance work. with clear water.
often transported in the course
of operation, it should be
cleaned out with clear water
after every use.
the function of the loating switch
should be checked every 3
months.
Remedies
– Check mains supply
– Bring floater in a higher
position
– Clean inlet sieve water jet
– Reset hose
– Place pump properly on shaft
ground
– Clean inlet sieve
– Clean pump and replace
dirty and abrasive water worn-out parts
– Remove mains plug. Clean
due to dirty water pump and shaft
– Maximum temperature is
stops pump 40° C. Please regard!