Installation - EINHELL Royal TMP 500-S NIRO Bedienungsanleitung

Anleitung TMP 500 08.11.2001 8:03 Uhr
G Access on the part of children
Before start-up, note the
following!
G The pump can be connected to
any shock-proof plug which has
Consistency
been installed according to regu-
Your submersible pump is designa-
lations. The plug must have a
ted for the circulation of water with
supply voltage of 230 V ~ 50 Hz.
a maximum temperature of 40° C.
Fuse min. 6 Amp.
This pump may not be used for
other fluids, especially motor fuels,
Caution:
cleaning fluids, and other chemical
When the pump is to be used
products!
near swimming pools or garden
ponds and in their area of pro-

Installation

tection, it must be equipped with
The submersible motor pumps is
a ground-fault circuit interruptor
installed as follows:
with a nominal trip current of
G In a stationary position with fixed
max. 30 mA (according to VDE
0700, part 702, 738).
Please contact your electrician!
G in a stationary position with a fle-
Attention!
(Important for your own security)
Please note!
Before starting to run your new
You should never install the pump
submersible pump, please have the
by suspending it unsupported from
following items checked by an
its delivery pipe or power cable.
expert:
The submersible motor pump must
G Ground connection
be suspended from the specially
G Zero conductor
provided handle or be placed on
G Fault current breaker switch
the bottom of the shaft. To guaran-
must correspond the the safety
tee that the pump works properly,
regulations of the power plants
the bottom of the shaft must be
and they must work faultessly.
kept free of sludge and dirt of all
G The electrical connections must
kinds.
be protected from moisture.
If the level of water sinks too far,
G If there is danger of looding, the
any sludge in the shaft will dry out
electrical connections must be
quickly and stop the pump from
taken to higher ground.
starting up. It is necessary, there-
G Circulation of aggressiv fluids, as
fore, to check the submersible
well as the circulation of abra-
motor pump regularly (by carrying
sive materials must be avoided
out start-up tests).
at all costs.
The floater is adjusted in a way that
G The submersible motor-driven
the pump can immediately be star-
pump must be protected from
ted
frost.
G The pump must be protected
from running dry.
Seite 5
Note!
should also be prevented with
The pump shaft should have mini-
appropriate measures.
mum dimensions of 40 x 40 x 50
cm, so that the floating switch can
move freely.
Mains supply
Your new submersible pump is
equipped with a shock-proof plug
according to regulations. The pump
is designed to be connect-ed to a
220/230 V ~ 50 Hz safety socket.
Make sure that the socket is suffi-
ciently secured (min. 6 Amp.) and
is in excellent condition. Introduce
the plug into the socket and the
pump is ready to go.
pipeline
Important Note!
or
If the mains cable or plug suffers
xible hose pipe.
any damage from external action,
repairs to the cable are prohibited.
Important!
This work may only be performed
by a qualified electrician or your
Einhell Customer Service.
Areas of use
This pump is used primarily as cel-
lar pump. When installed in a shaft,
this pump provides protection from
flooding.
The pump can however, be used
everywhere where water is to be
moved, for instance in the house-
hold, in farming, in the garden or
yard, in sanitation installations, and
many other ways as well.
GB
5