Technical Data; Intended Use; Safety Information - EINHELL Global OF-G 1100E Bedienungsanleitung

Anleitung OF-G 1100 E 12spr.
1. Machine layout (Fig. 1 and 2)
1 ON/OFF switch
2 Speed selector
3 Scale
4 Depth stop
5 Thumb screw for setting the depth stop
6 Turret stop
7 Routing base
8 Router cover
9 Thumb screw for fixing the parallel stop
10 Spindle lock
11 Handles
12 Clamping handle
13 Mounting hole for the parallel stop
14 Extractor socket
15 Clamping nut
16 Spindle
17 Guide bars for the parallel stop
18 Parallel stop
19 Device for fine adjustment of the parallel stop
20 Open-ended spanner
21 Trammel point
22 Guide bush

2. Technical data

Voltage:
Power consumption:
Idle speed:
Stroke/routing depth:
Collet:
For moulding cutters:
Safety insulated
Weight:
Sound pressure level LPA
Sound power level LWA
Vibration ah :
w

3. Intended use

The router is ideal for the processing of wood and
plastic, for the removal of knots, for the cutting of
grooves and recesses, and for the copying of curves
and lettering etc.
It is prohibited to use the router to process metal,
stone and other materials.
The machine is to be used only for its intended
purpose.
Any use beyond its intended purpose is a case of
mis-use. Liability for damage or injury resulting from
such a case of mis-use shall rest with the user or
operator and not with the manufacturer.
24.10.2001 10:50 Uhr
4. Important information
Please read the operating instructions carefully and
note their contents. Use these operating instructions
to acquaint yourself with the machine, its proper use
and essential safety precautions. Keep the operating
instructions together with the router.

Safety information

230 V - 50 Hz
1100 W
8,000 - 26,000 rpm
35 mm
Ø 8 and Ø 6 mm
max. Ø 40 mm
4.6 kg
94.2 dB(A)
107.2 dB(A)
2
4.92 m/s
Seite 7
Make sure the machine is switched off before
inserting the plug in the socket-outlet.
Clamp the workpiece securely to prevent it from
slipping.
Always run the cable away from the back of the
machine.
Always remove the plug from the socket-outlet
before doing any work on the machine.
Be sure to use only cutters with the correct shaft
diameter and suitable speed rating for your
router.
Check that the cutter is fitted securely before
starting up the machine.
Always make sure of your footing while using the
machine.
The direction of routing must always be opposite
to the cutter's direction of rotation.
Do not feed the cutter into the workpiece until it
is running.
Always guide the router with both hands.
Never exceed the maximum speed specified for
the cutter.
Make allowance for the machine's reaction
torque, particularly if the cutter jams.
When you are finished, allow the machine to
glide back into starting position.
Use only properly ground cutters.
Mount the cutter with friction locking.
Depending on the material, deeper cuts should
be performed in several passes.
The level of noise at the workplace may exceed
85 dB(A). In this case you will need to introduce
noise protection measures for the user. The
noise produced by this electric tool was
measured in accordance with EN 50144-1.
Vibration emission was measured in accordance
with EN 50144-1.
Ear muffs must be worn when operating the
router.
GB
7