Items Supplied; Technical Data - EINHELL EGS 2600 Bedienungsanleitung

Anleitung EGS 2600 16042003
GB
Environmental protection
Please remember that packaging, old batteries and
defective storage batteries do not belong in your
household refuse. Dispose of these items through the
proper channels.

2. Items supplied

1 energy station with compressor
1 energy station
1 power supply unit for charging
1 connecting cable with cigarette lighter plug
1 valve adapter set

3. Technical data

Storage battery: 12 V / 17 Ah
Output voltages / 12 V / 10 A via 1 cigarette
max. current consumption: lighter socket
Starting aid: 12 V / 600 A max. 5 sec.
Mains voltage: 230 V ~ 50 Hz
Output from power supply unit:
Nominal voltage:
Nominal current:
Nominal power:
Lamp 12 V / 3 W
Compressor 12 V/18 bar
4. Charging the energy station
(Important! Move the ON/OFF switch (Fig.
1/Item 1) to „OFF".)
4.1 Charging the energy station with the power
supply unit
1. Plug the connecting cable of the supplied power
supply unit in the charging socket „RECHARGE"
(Figure 1 / Item 2) on the unit.
2. Plug the power supply unit into a mains socket
outlet for 230 V ~ 50 Hz. The red LED indicator
(Fig. 1/Item 3) flashes.
3. It takes around 30 hours to charge the energy
station.
¼
Pressing the red pushbutton (Fig. 1/Item 4)
displays the charge state of the built-in battery on
the voltage meter (Fig. 1/Item 5).
10
17.04.2003 9:59 Uhr
4.2 Charging the energy station with the
automobile adapter cable
The energy station can be charged through the
automobile's cigarette lighter socket.
IMPORTANT: The energy station battery has a 12
volt charge capacity. You should only charge the
energy station when en route, as otherwise the unit
will run down the vehicle's battery.
Never start the vehicle as long as the automobile
adapter cable is connected to the cigarette lighter
socket.
¼
Insert the 12 volt plug of the automobile adapter
cable into the automobile's cigarette lighter
socket and insert the other end of the cable into
the charging jack of the energy station marked
„Recharge".
5. Outputs
Output 12 V cigarette lighter socket. max 10 A.
¼
The 12 V output (Figure 1 / Item 8) can be loaded
with max. 10 A, i.e. you have max. 10 A at your
disposal.
¼
12 V
Check the power and power consumption values
of the consumer to ensure that you do not
1000 mA
overload the energy station. If you only know the
12 VA
power data of the consumer you can calculate
the max. current very easily.
Example:
Consumer: 12 V / 50 W
The current consumption is 50 W / 12 V
= 4.17 A
¼
Use the supplied connecting cable to link the 12V
output socket with a suitable consumer
¼
Remove the caps to use the 12 V output and
connect the consumer.
6. Operating hours of typical
consumers
The appliances listed below are typical 12V
consumers. Their actual operating time depends on
the power consumption of the particular model and
the battery charge level.
Seite 10