Klarstein Baltrum Bedienungsanleitung Seite 22

EN
22
7. The factory preset temperature is 24 °C. The temperature can be adjusted by
pressing the + and - keys. If no entry is made within 5 seconds, this value is
automatically stored.
Timer (all items)
1. If you press the Timer button, you can set the time until the unit switches off
automatically. The timer indicator lights up. The screen displays the hour in the first
two digits and the hour unit "h" in the last digit.
2. The + and - buttons are illuminated. Adjust the time until the unit switches off by
pressing the + and - buttons. If no key is pressed within 5 seconds, your setting is
automatically confirmed. To confirm the time, you can also press the Timer button
again immediately after entering it. The maximum setting is 24 h, the minimum
setting is 0 h (no timer is activated).
3. After the timer setting has been completed, the Timer button will light up and the
setting temperature will be displayed on the screen again. At the same time, the +
and - buttons light up only slightly.
4. The timer can be set independently of the selected heating mode.
If you want to display the remaining time until the timer expires, press the button
again. The + and - buttons will then also light up again and you can adjust the time
until automatic switch-off if desired.
Temperature setting (Item 10035033)
1. When you press the temperature button, the + and - buttons and the temperature
display light up. The temperature is displayed on the screen as follows: The first two
digits indicate the temperature and the last digit shows the unit "°C".
2. The factory-set temperature is 24 °C. The temperature can be adjusted by pressing
the + and - keys (temperature setting range 7 - 35 °C).
3. If you press and hold the temperature key for 5 seconds when the machine is
working, you can change the temperature unit from "°C" to "°F". If you then press
the temperature button again for 5 seconds, you can change the temperature unit
from "°F" to "°C" again.
4. The factory-set temperature is 75 °F and the temperature setting range is 45 -
95 °F).
5. The device has a memory function for the temperature unit. Even after a power
failure, the last temperature unit set is restored.
Fan (Modell 10035034)
1. When you press the fan button, the fan indicator lights up and the fan motor starts
running.
2. If you press the fan button again, the fan indicator goes out and the fan motor stops
running.
Increase/ Decrease (Modell 10035033)
1. If no temperature setting or timer setting has been made, the + and - buttons light up
only dimly and do not react when pressed.
2. If a temperature and/or timer setting has been made, the + and - buttons light up
and are activated.
3. The temperature button must be pressed before setting the temperature.