Klarstein Baltrum Bedienungsanleitung Seite 21

Caution: Danger of Scalding.
Do not touch the heater during operation. The housing will become hot.
ON/Standby (all items)
1. Click on the key . If no other setting has been made, the unit runs at the highest
level (the factory-set temperature is 24 °C). The key
displays „24 °C". The other 5 keys only light up weakly.
2. Pressing again switches the device into standby. The key
of all other keys is off.
3. The device has a memory function. If you turn on the machine after putting it into
standby mode, the machine will return to the previous mode.
Modes (Item 10035033)
1. The mode key switch follows the order of high → middle → low → high → middle...
gear cycle. The middle one of the three digital tubes displays the "3→2→1,3→2..."
gear cycle in turn.
2. When the mode is set and set, the indicator light in the middle of the mode key is
highlighted, and a bit in the middle of the display screen shows the current setting
gear. The display shows the setting temperature value.
3. In all three modes, the temperature can be adjusted in the range of 7 °C - 35 °C.
The heating function can be switched on/off by the set temperature and the
temperature determined by the NTC sensor. To adjust the temperature, press the +
or - buttons.
Modes (Item 10035034)
1. The mode key switch follows the order of high → middle → low → high → middle...
gear cycle. The middle one of the three digital tubes displays the "3→2→1,3→2..."
gear cycle in turn.
2. When the mode is set, the "+" key /"-" key icon lamp is highlighted, and the point
pressing the + /- keys can increase or decrease the setting temperature of each
heating level.
3. When the mode is set, the indicator light in the middle of the mode key is
highlighted, and a bit in the middle of the display shows the current level set.
After the mode is set for 5 seconds, the three-digit digital tube displays the set
temperature value instead; or when the "+" and "-" key, the display indicates the set
temperature value.
4. Five seconds after you have completed the temperature setting, the + and - buttons
light up only slightly.
5. In the three modes, a temperature between 7 and 35 °C can be set and the heating
function can be switched on/off using the set temperature and the temperature
detected by the NTC sensor. To do this, press the + or - buttons.
6. Temperature content is displayed by a three-digit digital tube, the first two digits
display the temperature, and the last digit with the digital tube "dot" displays "°C",
lights up and the screen
dims. The illumination
EN
21