Lenze E94APNE0 Serie Montageanleitung Seite 26

Overview
Standard device 0
Pos. Description
X11 24 V supply
X12
4 digital outputs
1 digital input
2
Nameplate, retractable
3
Setting of mains voltage/brake chopper threshold
4
Upper cap
The LED display enables fast indication of several operating states.
LED Labelling
−
OVERHEAT
MAINS
BRCHOP FAIL
24 V
BRCHOP ON
SSP94LED21
Pos. Symbol
{
}
5
'
Installation backplane 1
Pos. Description
X111
Mains (supply from above, e.g. from top filters)
DC−bus voltage (compatible with 9300 series)
X112
Mains (supply from below, e.g. from built−on filter)
External brake resistor
X109 DC−bus busbar +
X110 DC busbar −
6
EMC shield clamp
© 2009 Lenze Automation GmbH, Grünstraße 36, D−40667 Meerbusch
No part of this documentation may be reproduced or made accessible to third parties without written consent by Lenze Automa-
tion GmbH.
All information given in this documentation has been selected carefully and complies with the hardware and software described.
Nevertheless, discrepancies cannot be ruled out. We do not take any responsibility or liability for any damage that may occur. Ne-
cessary corrections will be included in subsequent editions.
26
Colour Description
− −
Red Overtemperature
Green Mains voltage OK
Red Short circuit on brake chopper
Green 24 V supply voltage OK
Yellow Brake chopper active
Description
Long discharge time: All power terminals carry hazardous voltages for at
least 3 minutes after mains disconnection!
High discharge current: Fixed installation and PE connection to EN 61800−5−1
required!
Electrostatic sensitive devices: Before working on the device, personnel must
ensure that they are free of electrostatic charge!
l
Direct connection of
9400 axis modules,
device sizes 1 ... 3
EDK94PNE36 DE/EN/FR/ES/IT 3.0