avidsen V300 Bedienungsanleitung Seite 73

L1 L2 L3 L4
Accélération
OK PROG
L1 L2 L3 L4
Réglage accélération
+ : augmente l'accération
– : diminue l'accélération
réglable de 0 à 4
OK
L1 L2 L3 L4
Enregistre réglage*
MENU 0
* cette modification nécessite de refaire un auto-apprentissage
3.2.1. ACCELERATION/DECELERATION AT
END OF TRAVEL
The acceleration at the start of the panel opening
process can be adjusted from a level of 0 to 4. The
higher this value, the more time the gate will take
to reach its nominal speed. The default level is 3,
at which the gate takes about 4 seconds to open.
It may be useful to reduce the acceleration for a
softer start.
To adjust the acceleration, follow the procedure
below
• Press PROG for 3 seconds. L0 will flash once
and L1 will turn on.
• Press PROG for 3 seconds. L0 will flash twice.
• Press OK and the number of LEDs that turn on
will indicate the set value.
• Use the "+" and "-" buttons to change this value.
• Press OK to confirm this value. All the LEDs will
turn on and off to confirm the operation.
NOTE: If the acceleration setting is changed, self-
learning must be repeated.
3.2.2. PHOTOCELL MODE
The photocells are active when the panels close
because they are placed between the posts (pair
1) to secure the passage between panels.
The installation of a second set of photocells is
useful to completely protect the gate movement
area during closing and before opening:
+
L1 L2 L3 L4
– Mode photocellules
OK PROG
L1 L2 L3 L4
Mode photocellules
– et + pour régler la valeur
0 : inactives en début d'ouverture
(par défaut)
1 : actives en début d'ouverture
OK
L1 L2 L3 L4
Enregistre réglage
MENU 0
D - BEGINNING OPERATION
+
L1 L2 L3 L4
Type de portail
–
OK PROG
L1 L2 L3 L4
Type de portail
– et + pour régler la valeur
0 : portail à 2 battants (par
défaut)
1 : portail à 1 battant (portillon)
OK
L1 L2 L3 L4
Enregistre réglage*
MENU 0
RX1
RX2
In that case, the system must verify that its infrared
beam is not obstructed before starting to open the
panels. But by default, photocells are only tested
during closure.
To activate or deactivate photocells at the
beginning of the opening process, follow the
procedure below
• Press PROG for 3 seconds. L0 will flash once
and L1 will turn on.
• Press PROG for 3 seconds. L0 will flash twice.
• Press "+" once. L2 will turn on instead of L1.
• Press OK.
+
L1 L2 L3 L4
Tolérance butée
–
OK PROG
L1 L2 L3 L4
Réglage tolérance
+ : augmente la tolérance
– : diminue la tolérance
réglable de 0 à 4
OK
L1 L2 L3 L4
Enregistre réglage*
MENU 0
pair 1
pair 2
Inner side of the property
view from above
TX1
TX2
29 EN