Stihl Laser 2-in-1 Gebrauchsanleitung Seite 12

G
STIHL Laser 2-in-1
The STIHL Laser 2-in-1 helps you check the direction of fall when making
the felling notch. In addition, it can be used as a measuring aid when
bucking (length 25 - 100 cm; max. 150 cm). Direction of fall and bucking
length are indicated by a red laser beam.
Special safety precautions must be observed when working with
a chainsaw and the Laser 2-in-1.
Mount the Laser 2-in-1 only to chainsaws approved by STIHL and only
with the original STIHL holder. If you have any questions in this respect,
consult a servicing dealer in order to avoid the risk of accidents and
damage to the unit.
It is important you read and understand the instruction manual
before first use and keep the manual in a safe place for future
reference. Observe the safety precautions and specifications in
this instruction manual and the chainsaw instruction manual.
Non-observance of the instruction manual may result in serious
or even fatal injury.
Danger of Laser Beam
The retina can be damaged by prolonged exposure to the light
beam.
– Do not look directly at the light beam.
– Do not point the light beam at the eyes of other persons or animals.
– If a laser beam hits your eye, close your eyes immediately and turn
your head away from the beam.
– Do not point the laser beam at reflective surfaces.
– If the housing or lens is damaged, the level of radiation produced
may be higher than a class 2 laser, which can cause eye damage
even if you look at the laser source only momentarily.
– Never switch on the laser if its housing or lens is damaged.
Observe all applicable local safety regulations, standards and
ordinances.
The user is responsible for avoiding injury to third parties or damage to
their property.
Do not lend or rent your unit without the instruction manual. Be sure that
anyone using it understands the information contained in this manual.
12