Addition Of Surface Areas - Parkside PMML 5 A2 Bedienungs- Und Sicherheitshinweise

Note: You can switch between m²
and sq.ft. To switch between m² and
sq.ft, press and hold the MODE button
for 3 seconds. The measurement
10
unit
22
Addition of surface
areas
1. Measure an area as described in the
section "Measuring surface areas".
2. Press the Memory button
symbol "M+"
in the display
surface area is now saved.
3. Press the MODE button
product is now ready for the second
measurement.
4. Measure the next surface area as
described in the section "Measuring
surface areas".
5. Press the Memory button
The result of the first measurement
will be shown and blinking in the
lower row
6. Press the + / = button
Both measurements are added and
30 GB
will be changed.
will be appeared
24
. The measured
2
of the display
21
. Saving
4
. The
10
again.
4
.
2
again.
7