Single Distance Measurement Mode - Parkside PMML 5 A2 Bedienungs- Und Sicherheitshinweise

- If a definitive measurement is not possible,
the display shows the "Err" information.
The measurement must then be repeated.
Single distance
measurement mode
1. Slide the function switch
"MEAS / DETECT" mode. The display
switches itself on. If display
2
is not switched on, briefly press the
POWER button
display
meter and feet / inch. To switch be-
tween meter and feet / inch, press
and hold the MODE button
3 seconds. The measurement unit
will be changed.
Note: The measuring unit
be changed after any measurement
by following above mentioned step 1.
- Measurements start from the meas-
urement starting edge
the bottom side of the product is the
distance measuring reference point
.
25
24 GB
to switch on the
12
. You can switch between
2
to
9
2
for
10
22
can also
22
. It means,
1a