Parkside PMML 5 A2 Bedienungs- Und Sicherheitshinweise Seite 35

- Incorrect measurements can occur de-
pending on the nature of the examined
wall. Check therefore before every
measurement the position of a known
wooden or metal beam, or a known
power line. If these are not detected by
the device, the substrate is not suitable
for a search with this device.
- Avoid touching the LC display during
measurements as it may affect the accu-
racy of the device.
- Please note that power lines can also be
located as metal or as beams. Always
use the additional voltage search, so
that you can exclude any incorrect inter-
pretations.
- Please note that metal beams are also
detected in the Beam search "STUD"
function. If you find a beam and you want
to be sure that it is not a metal beam
(or for example a water pipe), use the
additional Metal search "METAL".
- Depending on the wall thickness and
material, it is possible that the detector
may signal a finding, before it is over
the material. In this case mark the start
GB 35