Adjusting The Injection Unit Quantity En - Abicor Binzel BRS-LCi Betriebsanleitung

6 Putting into operation
5 Check the clearance between the proximity switch (1) and the transmitter disc (2) and correct it if
necessary.
6 Loosen the screws (5).
7 Move the proximity switch (1) axially and tighten the screws (5).
8 Check the freewheeling of the transmitter disc (2) by turning the motor.
6.8 Adjusting the injection unit quantity
Cleaning unit
1
Injection and air blast unit
2
Adjusting the injection unit fluid quantity
Fig. 9
For adjusting the spray quantity, the system must be provided with compressed air. In order to assess the
function and the spray quantity, the solenoid valve Y3 must be switched.
 Fig. 13 Connecting the pneumatic system on page EN-16
Danger of crushing
Limbs can be drawn in and crushed by moving parts (milling cutter, clamping unit).
• Do not reach between moving parts.
Damage to the eyes
Sprayed release agent may damage the eyes.
• Wear safety goggles.
• Only adjust release agent by switching the solenoid valve Y3.
1 Connect siphon hose (5) to the release agent cylinder if necessary.
2 Switch on Y4.
3 Adjust the quantity of release agent by means of the adjusting screw (4).
4 Switch off Y4.
EN - 12
1 2
6 5
Extraction hose (release agent)
3
Adjusting screw
4
WARNING
WARNING
3
4
Extraction hose (release agent) 6
5
BRS-LCi
Supply line (compressed-air
motor)