Mounting The Milling Cutter En; Setting Up The Clamping Position En - Abicor Binzel BRS-LCi Betriebsanleitung

6 Putting into operation
6.4 Mounting the milling cutter
1 Clamping device
Mounting the milling cutter
Fig. 5
NOTE
• Only use appropriate tools with a suitable width across flats when changing the milling cutter. Milling
1 Insert the milling cutter (2) into the clamping device (1).
2 Secure the milling cutter (2) by means of tools (3).
6.5 Setting up the clamping position
1 Gas nozzle
Top view of cleaning station BRS-LCi
Fig. 6
1 Move the torch with the gas nozzle (1) vertically to the tool axis (milling cutter axis) over the cleaning
station BRS-LCi (2) .
2 Move to the clamping position. Make sure that the cylindrical part of the gas nozzle (1) lies evenly
against the V-block (1).
EN - 10
1
2 Milling cutter
cutter seat SW 27, milling cutter SW 17.
1
2 V-block
2
3
3 Tool
2
3
3 Cleaning station BRS-LCi
BRS-LCi