Adjusting The Proximity Switch En; Adjusting The Injection Unit Quantity En - Abicor Binzel BRS-LCi Betriebsanleitung

6 Putting into operation
6.7 Adjusting the proximity switch
NOTICE
• Observe the clearance (6-9 mm) between the proximity switch (1) and the retaining sheet (3).
• The proximity switch is equipped with an LED for controlling the switching output.
1 Proximity switch
2 Transmitter disc
Abb. 9 Adjusting the proximity switch
1 Loosen the screws (4).
2 Move the retaining sheet (3) vertically in the area of the elongated slot.
3 Adjust the proximity switch (1) to the center of the transmitter disc (2).
4 Fasten the retaining sheet (3) by means of screws (4).
5 Check the clearance between the proximity switch (1) and the transmitter disc (2) and correct it if
necessary.
6 Loosen the screws (5).
7 Move the proximity switch (1) axially and tighten the screws (5).
8 Check the freewheeling of the transmitter disc (2) by turning the motor.
6.8 Adjusting the injection unit quantity
1 Cleaning unit
2 Injection and air blast unit
Abb. 10 Adjusting the injection unit fluid quantity
EN - 14
1
5 4
3 Retaining sheet
4 Screws
1 2
6 5
3 Extraction hose (release agent)
4 Adjusting screw
2
3
5 Screws
3
4
5 Extraction hose (release agent) 6
BRS-LCi
Supply line (compressed-air
motor)
BAL.0149.0 • 2017-05-17