Instructions For Installing A Vesa Compliant Arm - Sharp LL-T15A1 Bedienungsanleitung

Instructions for installing a VESA compliant arm

An arm based on the VESA standard can be at-
tached to the monitor. The arm must be purchased
separately.
When choosing the arm to be installed please take
note of the following points.
- The arm should be compatible with the VESA
standard, and there must be a gap of at least 75
mm x 75 mm between the screw holes on the
section to be attached.
- The arm must not fall off or break off after being
attached to the monitor.
Note:
- The same thing about the adapter cord and also
RGB!!!!
- Please be careful not to hurt your fingers or injure
yourself.
1. Turn off the power switch and remove the AC
adapter from the monitor's power terminal.
2. Remove the stand cover.
Pull the lower section of the stand cover upward.
Stand cover
3. Being careful not to damage the monitor, spread
out a soft cloth and lay the monitor on it display-
side down.
4. Remove the four screws and then remove the
stand from the monitor.
Information
The stand is specially made for use with this
monitor. Once having removed the stand, never
attempt to attach it to another device.
Once having removed the screws, store them
together with the stand and if the stand is ever
re-attached be sure to use the original screws.
Using different screws could lead to malfunction
5. Attach the arm to the monitor with four screws.
Information
The screws used to
attach the arm should be
M4 screws with a length
of 4 mm ~ 6 mm protrud-
ing from the surface to be
attached. Using any other
kind of screw may lead to
the monitor falling off or
damage to the internal
part of the monitor.
6. Connect the AC adapter to the monitor's power
terminal.
24
4 ~ 6 mm
Screw used to
attach arm
Arm
Part of monitor to
which arm is at-
tached