Instructions For Attaching A Vesa Compliant Arm - Sharp LL-T2010 Bedienungsanleitung

Instructions for attaching a VESA compliant arm

An arm or stand based on the VESA standard
(commercially available) can be attached to the
monitor.
Procurement of the arm or stand is at the custom-
er's discretion.
Arms or stands able to be used
Attachments must satisfy the following.
- Compatible with the VESA standard.
- Have a gap of 100 mm x 100 mm between the
screw holes on the section to be attached.
- Not be likely to fall off or break off after being
attached to the monitor.
How to attach the arm or stand
CAUTION!
Be careful not to cut or jam your fingers.
Note:
- Do not overly bend the cable or add extension
cords as this could lead to malfunction.
- While following these instructions, please also
refer to the installation instructions in the
operation manual included with the arm or stand.
1. Spread out a soft cloth on a suitable horizontal
surface.
2. Being careful not to damage the monitor, gently
lay the monitor on it display-side down.
3. Remove the stand cover.
(Rear View)
All manuals and user guides at all-guides.com
Stand cover
Lift one side
31
4. Remove the two screws, and remove the cover.
Cover
Two screws
5. Remove the four screws and then remove the
stand from the monitor.
Four screws
Stand
6. Attach the arm to the monitor with the four
screws.
Note:
- The screws used to attach the arm should be M4
screws with a length of 8 mm ~ 10 mm protruding
from the surface to be attached. Using different
screws could lead to malfunction or may lead to
the monitor falling off,internal damaged,personal
injury.
8 10mm
Screw used to attach arm
Arm
Part of monitor to which arm is
attached
Four screws