Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 EN – Quick installation guide
Select the power cables
Size the power cables according to local regulations to carry the nominal current given on
the type designation label of your drive.
Ensure the cooling
See table
E
on page
allowed operating temperature range of the drive without derating is -15 to +40 °C.
Protect the drive and input power cables
EN
See table
E
on page 76.
DA
Install the drive module into a cabinet
DE
See figure
B
on page 75:
See figure
C
on page 75:
•
ES
Remove the sheeting from the clear plastic shrouds from both sides.
See figure
D
on page 75:
•
Install the top metallic shroud to the drive module.
FI
•
Install the back shrouds to the drive module.
FR
Check the insulation of the input and motor cables and
the motor
IT
Check the insulation of the input cable according to local regulations before you connect it
to the drive.
NL
See figure
F
on page 76. Ground the motor cable shield at the motor end. For minimal
interference, make a 360-degree grounding at the cable lead-through, or keep the pig tail
short.
PL
Check the insulation of the motor and motor cable when the motor cable is disconnected
from the drive, see figure
PT
phase conductor and then between each phase conductor and the Protective Earth
conductor using a measuring voltage of 1000 V DC. The insulation resistance of an ABB
motor must exceed 100 Mohm (reference value at 25 °C or 77 °F). For the insulation
RU
resistance of other motors, consult the manufacturer's instructions. Note: Moisture inside
the motor casing will reduce the insulation resistance. If you suspect moisture, dry the
motor and repeat the measurement.
SV
TR
ZH
76
for the losses and the cooling air flow through the drive. The
G
on page 76. Measure the insulation resistance between each
Werbung
Inhaltsverzeichnis
