Dynamic Weighing - OHAUS SD-Serie Handbuch

Auto Shut-Off
•
after approximately four minutes of inactivity. This feature is only active
during battery operation.

Dynamic Weighing

1. With platform empty, press the UNITS Cal button until the
indicator • flashes next to the desired measuring unit.
2. Place a mass on the platform. The scale will show "-A-".
NOTE: If using a container, press ON/ZERO Off to tare the
weight and return to zero.
3. With a mass on the platform or container, a short press of
UNITS Cal will start the averaging countdown from
5 seconds.
4. The averaged weight is then displayed. The indicator •
stops flashing when the process is complete.
5. The display will hold until a button is pressed.
6. To repeat the process press UNITS Cal with a mass on the
platform or container.
7. To Exit, remove the mass from the platform or container and
press UNITS Cal.
Find Quality Products Online at:
: To extend battery life, the scale will automatically turn off
GlobalTestSupply
www.
SD SERIES BENCH SCALE EN-7
.com
sales@GlobalTestSupply.com