Low Battery Indication; Operation - OHAUS SD-Serie Handbuch

EN-6 SD SERIES BENCH SCALE

Low Battery Indication

•
display
approximately 12 hours of operation remain. When the battery is fully
depleted, the scale will momentarily display "Lo bAt" and shut off.

Operation

Power Up Test
•
is turned on, all display segments will appear for a short time, followed by
the software version. The display will then reset to zero.
Zero Function
•
returns to zero. When adding additional mass, the ON/ZERO Off button
may be used repeatedly until the full capacity of the scale is reached.
When a container is used, the ON/ZERO Off button may be used to
simulate a Tare function. Additional mass may then be added as a NET
weight. When removing both the sample and container from the scale, a
negative value may be displayed. Zero the scale again before subsequent
usage.
NOTE: The ON/ZERO Off button will perform a true zero setting function when
displayed values are within +2% of full capacity. Above 2%, the range is
limited to full capacity by subtraction.
Negative Values
•
zeroed value will be displayed as a negative number. To return to normal
operation, the negative value is cleared from the display by pressing the
ON/ZERO Off button .
Overload
•
displayed. Remove the load and the scale will return to normal operation.
Find Quality Products Online at:
: The battery symbol on the left side of the
indicates a low battery condition. When first displayed ,
: When the ON/ZERO Off button is pressed, the scale
: By pressing the ON/ZERO Off button, the scale display
: When a load is removed from the scale, any previously
: If the applied load exceeds the capacity of the scale, an "E" is
GlobalTestSupply
www. .com
sales@GlobalTestSupply.com