Dell PowerEdge 1855 Konfigurationsanleitung Seite 16

9 To set the DRAC/MC time, type:
10 If required, assign a static IP address using the following DRAC/MC CLI command:
11 Press <Enter>.
12 Type racadm getniccfg and press <Enter>.
13 If desired, enable Telnet access to the DRAC/MC using the following DRAC/MC CLI
14 Type racreset and press <Enter> to reset the controller.
15 Redirect the DRAC/MC serial console to the Ethernet switch module internal serial console
14
General System Configuration
Downloaded from www.Manualslib.com
racadm setractime
where:
- yyyy is a 4-digit year
- mm is the month
- dd is the day
- hh is the hour (24-hour clock)
- mm is the minute
- ss is the second
- mmmmmm is the number of microseconds
-s is a "+" or "-", indicating the sign of the offset
-off is the offset in minutes
For example, Monday, May 25, 2004, at 1:30:15 PM EST would be represented as:
racadm setractime -d 20040525133015.000000-300
racadm setniccfg -s [<ipAddress> <netmask> <gateway>]
The specific address information must be obtained from your network administrator. In the
following example, 192.168.0.120 is the DRAC/MC default static IP address, 255.255.255.0 is
the subnet mask address, and 192.168.1.1 is the gateway address.
racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.1.1
The current and static IP addresses are displayed.
command:
racadm config -g cfgSerial -o cfgSerialTelnetEnable 1
NOTE:
See "Enabling and Configuring the DRAC/MC to Use a Serial or Telnet Console" for additional
information.
interface by entering the following command:
connect switch-n
where n is the system chassis I/O module bay number in which the Ethernet switch module is
installed.
NOTE:
To switch back to the context of the DRAC/MC CLI command prompt, press <Enter><~><.>.
manuals search engine
–d yyyymmddhhmmss.mmmmmmsoff