8 Ensure that the Mirror Pair field for the remaining drive is set to Secondary.
9 Press <Esc> to exit the Adapter Properties Menu.
10 Select Save changes and exit this menu and press <Enter>.
11 Press <Esc> to exit the Main Menu.
12 Select Exit the Configuration Utility and press <Enter>.
Additional Integrated Mirroring Guidelines
•
•
•
•
10
General System Configuration
Downloaded from
www.Manualslib.com
The drive that is set to secondary will mirror the primary drive. All other data on the
secondary drive will be lost.
After pressing <Enter>, you are prompted to confirm the change by pressing <Enter> again
and then by pressing <F3>.
The server module reboots and shows mirrored status after POST.
The hard-drive status indicator does not display any status information until after the
operating system driver initialization has occurred. To check for status information of a hard
drive prior to operating system load, use <Ctrl><M> during POST. See the Dell PowerEdge
Expandable RAID Controller 4/IM User's Guide for more information. During normal
operation, the status indicator is off.
NOTE:
The hard-drive activity indicator functions normally before and after the operating system
driver initialization.
NOTICE:
If you use a drive with existing data, the data will be cleared before the hard drive is added to
a mirror.
It is recommended that any replacement drives should be blank and not previously
configured.
It is recommended that you replace hard drives in an integrated-mirror configuration with
drives of the same capacity.
After removing a hard drive in a hot-pluggable environment, wait at least 30 seconds prior
to installing the new hard drive.
manuals search engine