Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
58.3 kN
NR14ABC2
570 bar
P
= 570 bar
m
514 bar
max.
min.
The capacitive menu selection button may not work if touched using objects or when
wearing gloves, therefore always operate it using a bare finger.
BATTERY
BATTERY
4.2) SELECTION SCREENS:
the tool, can be changed by operating the touch button:
Enabling/disabling the LED Worklights
LED
ON
BATTERY
LED
OFF
BATTERY
Return to original factory settings / firmware version
10001
When the 'RESET' screen is displayed, return the tool to its factory setting by operating the touch
button for at least 3 seconds; a beep will confirm the setting.
RESET
SW:S1J41AH
4.3) WARNINGS:
BATTERY
LED
OFF
LED
BATTERY
ON
10001
RESET
SW:S1J41AH
11
OK
B600
To make a selected screen operational and appear at each start-up of the
OK
tool, operate the touch button for at least 3 seconds; a continuous beep
3 SEC.
will confirm the setting.
control parameters that cannot be set as automati upon start-up of
The RESET screen also shows the firmware version of the circuit board.
these appear during operation and notify the operator of the status of the tool:
LOW BATTERY: replace the battery.
NOTE: when the battery Vage falls below a minimum safety threshold, the
tool will not start; although it is still possible to end the work cycle in progress.
BATTERY TEMPERATURE HIGH: remove the battery and wait until it cools
down.
NO. OF CYCLES TO MAINTENANCE REACHED:
the tool continues to work however, it is recommended that it is sent to
Cembre for a complete overhaul (see § 5).
NOTE: this message, together with a beep, will reappear when the tool
has been idle for 30 seconds.
BATTERY
BATTERY
10001
RESET
SW:S1J41AH
(factory setting LED ON)
LED
OFF
ERROR
LED
ON
001
002
003
004
ERROR
001
002
003
004
When the screen is displayed,
touch the button for at least
3 seconds to deactivate or re-
activate operation of the LED
Worklights during tool use; a
continuous beep will confirm
the setting.
ERROR
001
002
003
004
Werbung
Inhaltsverzeichnis
