1.2. General Content Of The Ec-Declaration Of Conformity - Milnor 60044SP2 Wartung

Chapter 1. Machine Description, Identification, and Certification
Figure 1: Machine Data Plate
View of Data Plate (English text shown)
.
BIWUUL01 (Published)

1.2. General Content of the EC-Declaration of Conformity

Manufacturer: Pellerin Milnor Corporation
Hereby we declare under our sole responsibility that the machinery
Type (see the declaration for your machine)
Serial no (see the declaration for your machine)
Manufacturing date (see the declaration for your machine)
is in conformity with the provisions of
2006/42/EC (17 May 2006) - Machinery
2004/108/EC (15 December 2004) - Electromechanical compatibility
2006/95/EC (12 December 2006) - Low voltage
Pellerin Milnor Corporation certifies that the machine(s) listed above, manufactured in Kenner,
Louisiana, 70063, USA conform(s) as stipulated by schedule of verification of
ISO 10472-1:1997 - Safety requirements for industrial laundry machinery - Part 1: Common
requirements
ISO 10472-2:1997 - Safety requirements for industrial laundry machinery - Part 2: Washing
machines and washer-extractors
ISO 13857:2008 - Safety of machinery - Safety distances to prevent hazard zones being
reached by upper and lower limbs
EN 61000-6-3:2007/A1:2011 - Emission standard for residential, commercial and
light-industrial environments
EN 61000-6-4:2007/A1:2011 - Emission standard for industrial environments
EN 60204-1:2006/A1:2009 - Safety of machinery - Electrical equipment of machines, Part
One, General requirements.
PELLERIN MILNOR CORPORATION
— End of BIUUUF01 —
Book specs- Dates: 20120626 / 20120626 / 20150806 Lang: ENG01 Applic: HD6
10
Legend
1. Model number. See
inside the front cover of
this manual.
2. Data that uniquely
identifies your machine
3. Cylinder maximum
rotation speed in
revolutions per minute, if
applicable
4. Cylinder volume in the
units of measure shown,
if applicable
5. Piped utility requirements
6. Hydraulic oil pressure, if
applicable
7. Electrical requirements
8. Part number for
multi-unit machine, if
applicable.