Safety Instructions; Electrical Connection - Electrolux EOB3434 Benutzerinformation

4 www.electrolux.com
•
•
•
•
•

2. SAFETY INSTRUCTIONS

2.1 Installation
• Remove all the packaging.
• Do not install or use a damaged
• Obey the installation instruction
• Always be careful when you move the
• Do not pull the appliance by the
• Keep the minimum distance from the
• Make sure that the appliance is
• The sides of the appliance must stay

2.2 Electrical connection

Downloaded from www.Manualslib.com
Ensure that the appliance is switched off before
replacing the lamp to avoid the possibility of electric
shock.
Do not use a steam cleaner to clean the appliance.
Do not use harsh abrasive cleaners or sharp metal
scrapers to clean the glass door since they can
scratch the surface, which may result in shattering of
the glass.
If the supply cord is damaged, it must be replaced by
the manufacturer, its Authorised Service Centre or
similarly qualified persons in order to avoid a hazard.
To remove the shelf supports first pull the front of the
shelf support and then the rear end away from the
side walls. Install the shelf supports in the opposite
sequence.
WARNING!
Only a qualified person must
install this appliance.
appliance.
supplied with the appliance.
appliance because it is heavy. Always
wear safety gloves.
handle.
other appliances and units.
installed below and adjacent safe
structures.
adjacent to appliances or to units with
the same height.
WARNING!
Risk of fire and electrical
shock.
manuals search engine
• All electrical connections should be
made by a qualified electrician.
• The appliance must be earthed.
• Make sure that the electrical
information on the rating plate agrees
with the power supply. If not, contact
an electrician.
• Always use a correctly installed
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to
the mains plug and to the mains
cable. Should the mains cable need to
be replaced, this must be carried out
by our Authorised Service Centre.
• Do not let mains cables touch or
come near the appliance door,
especially when the door is hot.
• The shock protection of live and
insulated parts must be fastened in
such a way that it cannot be removed
without tools.
• Connect the mains plug to the mains
socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.
• If the mains socket is loose, do not
connect the mains plug.