Electrolux EOB3434 Benutzerinformation Seite 22

22 www.electrolux.com
10.3 Cleaning the cavity
embossment
The cleaning procedure removes
limestone residual from the cavity
embossment after the humidity cooking
process.
1. Put 250 ml of white vinegar into the
2. Let the vinegar dissolve the residual
3. Clean the cavity with warm water and
10.4 Cleaning the door gasket
• Regularly do a check of the door
• To clean the door gasket, refer to the
10.5 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
1. Pull the front of the shelf support
Downloaded from www.Manualslib.com
We recommend to do the
cleaning procedure at least
every 5 - 10 True Fan
Cooking PLUS cycles.
cavity embossment at the bottom of
the oven.
Use maximum 6% vinegar without
herbs.
limestone at the ambient temperature
for 30 minutes.
a soft cloth.
gasket. The door gasket is around the
frame of the oven cavity. Do not use
the appliance if the door gasket is
damaged. Contact an Authorised
Service Centre.
general information about cleaning.
away from the side wall.
manuals search engine
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must
point to the front.
10.6 Aqua cleaning
The Aqua cleaning procedure uses
humidity to help remove remaining fat
and food particles from the oven.
1. Put 200 ml of water into the cavity
embossment at the bottom of the
oven.
2. Set the True Fan Cooking PLUS
function and press the Plus
Steam button .
3. Set the temperature to 90 °C.
4. Let the appliance operate for 30
minutes.
5. Deactivate the appliance and let it
cool down.
6. When the appliance is cool, clean the
inner surfaces of the oven with a
cloth.
WARNING!
Make sure that the
appliance is cool before
you touch it. There is a
risk of burns.