Pilz PKB-M Bedienungsanleitung Seite 43

www.dplusa.fr
Stand-
still
Br.Mode
XXXX
deadtime
XX.Xs
Level1
XXX#
Level2
XXX#
OffDelay
XX.Xs
PKB-M, PKB-MS Operating Manual
DETECTION ET AUTOMATISME - 17 Rocade de la Croix St Georges - 77600 BUSSY ST GEORGES - Tél : 01.64.66.90.00 - Fax : 01.64.66.98.01 - mail : infos@dplusa.fr
Downloaded from www.Manualslib.com
Standstill
Only on the version with automatic standstill detection
Braking mode
XXXX Time: brake until preset time
Auto: brake until standstill
The following four parameters determine standstill detection. The control
logic covers 4 steps (1 to 4), where one step must always be complated
before the next step can begin: (1) start-up suppression time, (2) level 1
exceeded, (3) falls below level 2 and (4) braking current overrun.
The signal cycle can be seen on the standstill display.
Start-up suppression time (deadtime)
XX.X "Adjust time" in seconds; used also to suppress the settling
effects at the start of braking. Standstill detection during this
time is not possible.
Switch-on braking threshold
XXX Mid-value can be set between the highest and second highest
signal level: also used to switch off fault pulses
Switch-off braking threshold
xxx Value can be set below the switch-on threshold; determines the
beginning of the braking current overrun.
Braking current overrun
XX.X Time in seconds between the detected standstill and the actual
end of the braking process, i.e. braking current switched off.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
manuals search engine
13