Remote Control Ir-7 - EuroLite AKKU IP PAR 14 HCL QuickDMX Bedienungsanleitung

Remote control IR-7

The device must be activated for remote control. For this, set menu item INFRARED to ON. When actuating
a button, always direct the remote control towards the sensor. There must be no obstacles between remote
control and the sensor.
Notes:
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
• If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.DMX operation
Button Function
BLACKOUT LEDs off
AUTO
Automatic mode; program selection with (+)/(‒)
STROBE Strobe effect for automatic mode;
flash rate setting with (+)/(‒)
Running speed in
SPEED
setting with (+)/(‒)
DMX DMX mode
MANUAL Color mode; select colors with R/G/B/A/W/UV
setting with (+)/(‒)
FADE Color fade mode, press the FADE key again to turn
off the FADE function, use (+)/(‒) to set the FADE
program speed
1-9 Total brightness; 1 = dark, 9 = bright
33/40
automatic mode;
00128658, Version 1.0