EuroLite AKKU IP PAR 14 HCL QuickDMX Bedienungsanleitung Seite 32

Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAVE is indicated on the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.
Master/slave operation via QuickDMX
1 Set the master device and each slave device to the same transmission channel using the function SET
2.4G. Thus, the spotlights are paired.
2 Set the master unit to the desired operating mode and all slave units to SLAVE mode. The devices will
now operate in sync.
Energy-saving mode
The ECO mode offers the possibility to adjust the battery life.
1 Press the MENU button so many times until ECO is indicated in the display. Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to choose energy saving mode ON or OFF, or select super energy
saving mode S-ECO. Confirm with the ENTER button. In S-ECO mode the battery life is 26 hours with
one color and 6 hours with full light output.
QuickDMX transmission channel
You can use the SET 2.4G menu to set the wireless transmission channel for QuickDMX operation. Please
refer to the corresponding chapters for further explanation.
32/40 00128658, Version 1.0