If you are in a submenu, select the main menu as described in Section 7.1.
If DAB is being started for the first time, a complete station scan is
performed. The station list is then shown (see Section 11.4).
11.3 Performing a station scan
The automatic scan scans all DAB+ band III channels and thereby finds all stations
being broadcast within the reception area.
After the scan is complete, the first station is played back in alphanumeric
order.
>
In order to perform a complete scan, press the SCAN button. "Scan" appears
in the display. The scan starts and the progress bar appears in the display.
When completed, press or and OK to select a station.
>
Alternatively: press the MENU button and select using or [Scan]. Confirm
>
by pressing OK.
If no stations are found, check the antenna and change the installation
location if required (Section 6.3.1).
11.3.1 Manual scan
Proceed as follows if you want to run a station scan manually:
Select [Menu > Set Manually] and press the OK button.
>
>
Select a station frequency and press the OK button.
If stations are being broadcast on the selected frequency, this will be
indicated on the stability bar (see also Section 11.8). If these stations are not
currently included in your station list, they will now be stored there.
11.4 Selecting stations
You can check the stations found on the device. To do so press or .
>
>
To select a station press OK.
Alternatively, you can press the MENU button and use or to select >
>
[Station list].
11.5 Saving DAB stations
The favourites memory can store up to 12 stations.
The saved stations remain stored even in the event of a power cut.
DE
EN
FR
IT
NL
DA
PL
SK
SL
61