Preparing The Digitradio 601/631 For Operation; Connect And Align The Antenna; Connecting The Power Supply Unit; Insert The Batteries Into The Remote Control - TechniSat DIGITRADIO 601 Bedienungsanleitung

6.3 Preparing the DIGITRADIO 601/631 for operation

6.3.1 Connect and align the antenna

The number and quality of the stations to be received depend on the reception
conditions at the installation location. Excellent reception can be achieved using the
telescopic antenna.
> Remove the telescopic antenna from its holder, align it and extend it.
The exact alignment of the telescopic antenna is often important, in particular
on the outskirts of the DAB+ reception area. On the Internet you can quickly
find the location of the nearest transmission tower by visiting
de.
Start the first scan at a window pointing in the direction of the transmission
mast. If the weather conditions are poor, DAB+ reception may be limited.
Do not touch the telescopic antenna during station playback. This could
compromise the reception and lead to sound dropouts.

6.3.2 Connecting the power supply unit

Ensure that the operating voltage of the power supply unit matches the
mains voltage before you insert it into the wall socket.
WARNING!
Do not touch the mains plug with wet hands; electric shock hazard!
WARNING!
Route the mains cable in such a way that nobody can trip over it.
Use the supplied power cable to connect to the port marked DC IN (4) on
>
the reverse of the DIGITRADIO 601/631. Then connect the power cable to the
mains.

6.3.3 Insert the batteries into the remote control

> Open the battery compartment on the back of the remote control by pushing
it in the direction of the arrow.
> Insert the batteries (2 x AAA 1.5 V) in accordance with the polarity indicated
in the battery compartment.
54
www.dabplus.