Setting The Can Hardware; Initialising The Can Hardware - Tecsis P3427 Bedienungsanleitung

3. Commissioning

3.2 Setting the CAN hardware

Under the menu item "Extras" check "Settings" as to whether the CAN hardware used is
registered.
GB
When using a PCAN Dongle for the parallel port, the resources used (I/O address, inter-
rupt) have to be set (information on this is in the instructions that came with the PCAN
Dongle).
With the PCAN-USB adapter, this setting is not required. In the event of a change in the
CAN hardware, a restart of the software is needed.

3.3 Initialising the CAN hardware

Then select the required bit rate. To initialise the hardware, press the "CAN Init" button.
20 tecsis instruction manual CommunicationSoftware CANopen
®