Instrument Settings - Tecsis P3427 Bedienungsanleitung

5. Instrument settings

5. Instrument settings
The "Instrument settings" register enables a change in the Node ID and the bit rate of
the pressure sensor. In addition, further parameters can be configured here:
PDO transmission:
■
Synchronous operation: Response on every n
■
Cyclic operation: Measured values will be sent every x ms (max. 65535 ms)
■
On request (measured values will only be sent on request via RTR)
■
Auto-operational: Instrument status is immediately changed to "OPERATIONAL"
on switching on
Filter
Possible settings for the limit frequency.
Save settings
Via the appropriate input fields and then pressing the "Save settings" button, these
settings will be saved to the instrument.
The software carries out a reset of the instrument in order to activate the changed
parameters. If the Node ID has been changed, the connection must be re-established
with the new Node ID. If the bit rate has been modified, the CAN hardware will need to
be re-initialised.
tecsis instruction manual CommunicationSoftware CANopen
th
SYNC (n = 1...240)
®
GB
25