DeFelsko PosiTector 6000 Kurzanleitung Seite 5

Use when operating regularly on non-ferrous substrates.
The
current principle to shorten measurement time and extend
battery life. Useful when measuring coatings over plated steel.
Cal Memory
The current cal setting (ex. Cal 3) displays in the upper right
corner of the LCD. A stored cal setting can be restored when
you return to a particular part. Cal 1 can be adjusted but never
deleted, and is always made active with factory settings after a
Reset (pg. 4). A new cal setting cannot be created if a batch is
open with readings.
Converts the display from microns to mils and vice versa.
Reset (menu Reset) restores factory settings and returns the
Gage to a known condition. The following occurs:
- All batches, stored measurements, batch names and screen
- Calibration adjustments are returned to factory settings.
- Menu settings are returned to the following:
Perform a more thorough Hard Reset as follows:
1. Power down the Gage and wait 5 seconds.
2. Simultaneously press and hold the ( + ) and
buttons until the Reset symbol
This returns the Gage to a known, "out-of-the-box" condition.
Downloaded from www.Manualslib.com
N Lock
icon appears and the probe will only use the eddy
N
(Advanced models only)
Units
Reset
captures are erased.
Memory = OFF
Hi Res = OFF
Statistics = OFF
Hi Lo Alarm = OFF
Scan Mode = OFF
Auto Dim = ON
manuals search engine
(FN ferrous/non-ferrous combination probes only)
Setup Menu
Cal Lock = OFF
Bluetooth & Stream = OFF
WiFi & Access Point = OFF
Display = None
N Lock = OFF
appears.
4
center