Menu Operation - DeFelsko PosiTector 6000 Kurzanleitung

The PosiTector 6000 powers-up when the center navigation
button
powers down after approximately 5 minutes of no activity. All
settings are retained.
1. Remove the protective rubber cap (if supplied) from probe.
2. Power-up Gage by pressing the center navigation
3. Place the probe FLAT on the surface to be measured.
HOLD STEADY. When a valid measurement is calculated,
the Gage BEEPS twice and the measurement is displayed.
4. Lift probe AT LEAST 2 INCHES (5 cm) from the surface
between measurements - OR - leave probe on the surface
Gage functions are menu controlled. To access the Menu,
power-up the gage, then press the center navigation button.
To navigate, use the Up and Down buttons to scroll vertically and
Previous Page
(Exit)
Access the Menu
(Center/Select)
Downloaded from www.Manualslib.com
is pressed. To preserve battery life, the instrument
in the same location for continuous measurements.
to SELECT.
Up
Down
manuals search engine
Introduction
Quick Start

Menu Operation

Next Page
Press the
pages in a multipage menu.
Press the (-) button to return
to the previous menu or page.
Select Exit to exit from any menu.
1
button.
( + )
button to switch