DeFelsko PosiTector 6000 Kurzanleitung Seite 11

Before returning the instrument for service...
1. Install new or newly recharged batteries in the proper
2. Examine the probe tip for dirt or damage.
3. Perform a Hard Reset (pg. 4).
4. Place a plastic shim onto bare metal (steel or non-ferrous
5. If issue is not resolved, Update (pg. 9) your PosiTector
IMPORTANT:
If you must return the Gage for service, please fill out and
include the Service Form located at www.defelsko.com/support
with the Gage. Be sure to also include the probe, your company
name, company contact, telephone number and fax number or
email address.
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
Downloaded from www.Manualslib.com
Returning for Service
alignment as shown within battery compartment.
The probe should move up and down freely.
metal, depending upon whether you have an "F " or "N" probe)
and attempt a measurement. (see Verification, pg. 2)
gage body and re-attempt measurements.
Limited Warranty, Sole Remedy
and Limited Liability
© 2017 DeFelsko Corporation USA All Rights Reserved
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted,
in whole or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiSoft and PosiTector are trademarks of DeFelsko Corporation registered in
the U.S. and in other countries. Other brand or product names are trademarks or registered
trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is accurate.
DeFelsko is not responsible for printing or clerical errors.
manuals search engine
www.defelsko.com
10