Pan Detection; Residual Heat Indication; Power Function - Novy 3761 Montageanleitung Und Bedienungsanleitung

Pan detection

The pan detection ensures a perfect safety.
The induction doesn't work:
 If there is no pan on the heating zone or if this pan is not adapted to the induction. In this
case it is impossible to increase the power and the display shows [ U ]. This symbol
disappears when a pan is put on the heating zone.
 If the pan is removed from the heating zone the operation is stopped. The display shows [ U ].
The symbol [ U ] disappears when the pan is put back to the heating zone. The cooking
continues with the power level chosen before.
After use, switch the heat element off: don't let the pan detection [ U ] active.

Residual heat indication

After the switch-off of the hob, the heating zone is still hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zone may be touched without danger.
As far as the residual heat indicator is on light, don't touch the heating zone and don't put any
heat sensitive object on them. There are risks of burn and fire.

Power function

The Power function [ P ] grants a boost of power to the selected heating zone.
If this function is activated the heating zones works during 10 minutes with an ultra high power.
The booster is foreseen for example to heat up rapidely big quantities of water, like nuddles
cooking.
 Start up / Stop the Power function :
Action
Power selection
Zone selection
Stop the Power
 Start up / Stop the Super Powerr function :
Action
Super Power selection
Zone selection
Stop the Super Power
 Power management :
The hole cooking hob is equipped by a maximum of power. When the Power function is
activated, and not to exceed the maximum power, the electronic system orders to reduce
automatically the power level of an other heating zone. The display is blinking on [ 9 ] during a
few seconds and then shows the maximum of power allowed ( [ 6 ] or [ 8 ] ).
Heating zone selected
[ P ] is displayed
Control panel
Press 1x key [ P ]
Press key [ + ]
Press key [ - ]
Control panel
Press 2x key [ P ]
Press key [ + ]
Press key [ - ]
The other heating zone:
[ 9 ] goes to [ 7 ] or [ 8 ] depending the type of zone
50
Display
Control light on
[ P ]
[ 9 ]....[ 0 ]
Display
Control light blinking
[
[ 9 ]....[ 0 ]
(example: power level 9)
P ]