Service; Specific Safety Rules; Usage Conditions - Enar AVMU Gebrauchsanweisungen

4.5 SERVICE

4.6 SPECIFIC SAFETY RULES

5
For your own safety, as protection for others, and to avoid damage to the equipment, read carefully
the usage recommendations.
IN ADDITION, LOCAL COUNTRY ESTABLISHED ORDINANCES SHOULD BE RESPECTED.
AVMU MOTOR - FLEXIBLE SHAFT AND POKERS
Downloaded from www.Manualslib.com
Tool service MUST BE PERFORMED only by qualified repair personnel.
When servicing a tool, USE only identical replacement parts.
FOLLOW instructions in the Maintenance section of this manual.
For the proper operation of the motor, MAKE SURE that operators have been instructed in the
proper management of this machine.
The motor SHOULD ONLY BE USED in the specific jobs for with it the help of this manual.
Before connecting the motor to the electrical system, MAKE SURE that the voltage and frequency
coincide with the ones stated in the characteristics equipment plate, located in the top part of the
plastic housing.
ENSURE that all frame screws are tight before starting work.
TO AVOID the flattening of the cable by heavy machinery with could cause breakage.
DO NOT CONNECT THE FLEXIBLE SHAFT TO THE MOTOR WHEN THIS IS WORKING.
DO NOT OPERATE in the motor shaft when this is working and without transmission.
DON NOT WORK with transmission or poker in bad conditions, the motor overheats.
DO NOT WORK with the plastic housing broken.
DO NOT PERMIT untrained personnel to operate the motor or connections.
MAINTAIN free ventilation of air.
KEEP the motor in a clean and dry area.
MAKE SURE that the electrical cable is with the proper section and functioning properly (see section
3.3.2).
Before doing any type of repair, DISCONNECT the motor from the electrical system.
When connecting to a generator, MAKE SURE that the out tension and frequency is stable, right,
and has the proper power, (the converter's feeding voltage should not vary more than ± 5% as
stated on the motor's plate).
Proper protective equipment SHOULD BE USED because the acoustic power level of this machine
is 92 dB and the acoustic pressure level is 85.5 dB.
When finishing the job or when taking a break, the operator SHOULD UNPLUG, disconnect it from
the electrical system, and have it placed in such a way that it should not fall or tip

USAGE CONDITIONS

1. Before working, to be sure the hose joint nut is fastened to the motor (screwed to left).
2. Be sure the poker is well screwed to the flexible shaft (screwed to left).
3. Do not work with flexible shaft with big bends.
4. Do not overlubricate the shaft.
5. Do not keep working the poker out of the concrete more than 5 minutes.
6. Do not restrict the movement of the poker during the work.
7. Do not stop the poker inside the concrete.
8. Change the wear parts to avoid damage to the internal parts. (Check wearing table for the poker)
9. Do the maintenance with the kinds and quantities of recommended lubricants.
10. Proper protective equipment should be used because the acoustic power level of this machine is
92 dB (85,5 the pressure level)
11. the vibration that transmited to the operator does not exceed 2,5 m/s 2 of acceleration. (1,45 m/s 2
obtained value).
TAX1m, TAX1-5m, TAX2m, TAX3m, TAX4m, TAX5m
manuals search engine
AVMU - AX25, AX38, AX48, AX58
en
5