Troubleshooting; Ce Declaration Of Conformity; Available Accessories - Kindermann HDMI Switch 41 automatic 4K60 Inbetriebnahme- Und Bedienungsanleitung

11. Troubleshooting

Problems
No video signal on the display
No output signal despites correct
input signal
Display shows "no signal"
Switch cannot be controlled via
the RS232 port
The device charges itself statically
Note:
If the problem persists after following the troubleshooting steps above, contact your local dealer
or distributor for further assistance.

12. CE declaration of conformity

Note:
The current commissioning and operating instructions can be downloaded from our website:
www.kindermann.com
The currently valid CE declaration can be viewed and downloaded at the following URL:
https://shop.kindermann.de/erp/KCO/avs/5/5778/5778000154/12_Zertifizierungen/CE5778000154.pdf

13. Available accessories

• HDMI cable, type A, 19-pin (5809002 0xx)
• Active HDMI cable, type A, 19-pin (5809003 0xx)
Please contact your local dealer for further support or solutions.
5778 000 154 D / GB 2020-06
Kindermann GmbH · Mainparkring 3 · D-97246 Eibelstadt · E-Mail: info@kindermann.de · www.kindermann.com
Possible cause
The connection cables may not
be connected properly or may
be damaged
Poor quality of the connecting
cables
Wrong RS232 communication
parameters
Wrong pins used at the cables
Bad grounding
Änderungen vorbehalten / Subject to alterations
Solution
Check that the cables are
correctly connected and in
good condition
Replace the connecting cables
with high-quality cables or add
additional amplification compo-
nents to improve the signal quality
Check the communication
parameters
Check the pinning
Check the grounding
Printed in China