Parkside PDBS 1800 A1 Originalbetriebsanleitung Seite 23

■ Never use damaged compressed-air tools.
Maintain compressed-air tools with care. Check
regularly whether moving parts function correctly
and do not jam; check whether any parts are
broken or damaged to an extent that the com-
pressed-air tool will no longer operate correctly.
Check signs and labels for completeness and
readability. If damaged, have parts repaired
or replaced before using the compressed-air
tool. Many accidents are caused by poorly
maintained compressed-air tools.
■ This tool is not intended for use by persons
(including children) with limited physical,
physiological or intellectual abilities or lack
of experience and/or knowledge, unless they
are supervised by a person who is responsible
for their safety, or receive instructions from this
person on how to use the tool.
■ Do not allow children to play with the tool.
WARNING! RISK OF INJURY!
► Disconnect the compressed-air supply before
carrying out maintenance work.
■ RISK OF EXPLOSION! Never use gasoline or
other flammable liquids to clean the com-
pressed-air tool! Sparks can ignite vapours
remaining in the compressed-air tool and lead
to an explosion of the compressed air tool. Do
not operate the compressed-air tool in explosive
atmospheres or environments with flammable
liquids, gases or dust. Do not work with any
materials that are or could become inflammable
or explosive.
■ Use the tool only in the fields of application for
which it was designed!
■ Do not force the tool.
■ Never use hydrogen, oxygen, carbon dioxide
or other gas in bottles as sources of energy for
this tool, as this can lead to an explosion and
consequently serious injuries.
■ 20 │ GB │ IE
■ Maintain and clean the tool on a regular basis
as specified (see Section "Maintenance and
cleaning").
■ Check the tool for any possible defects before
use. Ensure that the tool is in good working
condition before every use.
■ Remain alert at all times! Unexpected move-
ments of the tool can cause dangers.
■ Do not overreach. Keep proper footing and
balance at all times. This provides for better
control over the compressed-air tool in unex-
pected situations.
■ Do not use the tool if its switch is defective. Any
tool that cannot be switched on or off is danger-
ous and must be repaired.
■ Keep compressed-air tools that are not being
used out of the reach of children. Do not allow
persons unfamiliar with the tool or these instruc-
tions to operate the tool. Compressed-air tools
are dangerous in the hands of inexperienced
users.
■ Treat the tool with care. Check whether moving
parts function correctly and do not jam; check
whether any parts are broken or damaged to
an extent that the tool will no longer operate
correctly. If damaged, have the tool repaired
before use. Many accidents are caused by
poorly maintained tools.
■ Switch off the tool when not in use.
■ Use personal protective equipment. Always
wear eye protection. Wearing protective equip-
ment such as a dust mask, non-slip safety shoes,
a helmet or hearing protection depending on
the type and use of the compressed-air tool
reduces the risk of personal injuries.
■ Check all connections and supply lines. All
maintenance units, couplings and hoses must
correspond to the tool parameters in terms of
pressure and air flow. If the pressure is too low,
the function of the tool will be compromised
and if the pressure is too high, this can cause
property damage and personal injury.
PDBS 1800 A1