Group Mode - Lutron GRAFIK Eye QS Schnell Installations- Und Betriebsanleitung

Daylight Sensor Setup

Group Mode

This step allows you to assign daylight sensors to a group of DALI loads connected
to the GRAFIK Eye QS control unit.
®
Daylight Sensor
1. If not already done, complete the steps on page 17, and
Daylight Groups
2. Use the Master buttons to highlight "Daylight Groups" and
Setup
3. Use the Master buttons to scroll through the list of available
Configure Groups
4. Use the Master buttons to scroll through the DALI devices on
Group 1
Group 1
Ballast 2/23
*Unassigned*
5. Press the Timeclock (back) button to return to the list of
OR
Group 1
Ballast 2/23
*Assigned*
OR
Group 1
Ballast 2/23
*Group 2*
Downloaded from www.Manualslib.com
Set Up Groups
select "Group Mode".
press the OK button to accept.
daylight groups. Up to 16 groups of DALI loads can be
defined. Press the OK button to accept.
the link. Press the OK button to add or remove the selected
device. The currently selected device will display its current
assignment status:
Unassigned if it is not assigned to any group
Assigned if it is assigned to the selected (displayed) group
Group x if it is currently assigned to another group (x = the
group number it is assigned to)
configurable groups, and repeat these steps to assign devices
to other groups.
Note: Each DALI device can be assigned to only one group.
Assigning a device already associated with another group will
replace its existing programming.
For additional information, see the complete installation and operation guide at www.lutron.com/qs
®
manuals search engine
1 9 2 10 3 11 4 12 5 13 6
(continued on next page)
GRAFIK Eye QS with DALI Quick Installation and Operation Guide 19
®
14 7 15 8 16
9-16
1-8
OK
Master
buttons
OK
button
Timeclock
(back) button