GYS GYSPOT ARCPULL 350 Handbuch Seite 27

GUN TOOLS
CHANGE THE GUN EARTH RODS
Removal of the rods
• Unscrew the two front screws in order to slightly release the case towards the front
of the gun.
• Slightly unscrew the two screws used to hold the rods.
• Pull the rods up to remove them.
Repositioning of the rods
• Insert the rods into their compartment.
• Adjust the length of the rods between their end and base according to the type of
parts to weld.
Insert to be welded
Threaded stud, threaded insert stud,
insulation nail, pulling ring
Pulling rivet rod
• Tighten up the two screws holding the rods.
• Reposition the hood
• Screw the front screws back on.
Note : When doing this, it is recommended to remove the electrode holder by loosening
the locking nut.
CHANGING THE ELECTRODE HOLDER
Removing the electrode holder
• If necessary, remove the pad and the cover of the earth
rods.
• Unscrew and release the locking ring with the ring holder
or threaded stud holder.
Repositioning of ring holder
• Place the electrode holder in the gun barrel.
• Screw the locking nut back on and check that the ring holder does not move.
The locking nut must be tightened by hand. Do not use a clamp.
GYSPOT ARCPULL 350
L (mm)
120
55
Front screw:
Earth rod holes:
Pad and
cover Earth rods
EN
Rod tightening screws:
L cm
Locking nut
27