Product Operation - GYS GYSPOT ARCPULL 350 Handbuch

PRODUCT OPERATION

When it is switched on, the product starts up again in the last operating mode using the last welding parameters set.
Changing the mode (Manual or Synergic) is done via the Main Menu.
WELDING IN MANUAL MODE
In Synergic Mode, the arc height, times and currents for the different phases are selected automatically by the machine.
The type of gas to be used is displayed on the screen. If the polarity of the gun is wrong, a message appears on the
display and the fault LED (red) of the gun flashes.
The different welding parameters are established for the inserts sold by GYS.
These synergies remain valid for longer inserts (≤45mm) as long as they are of the same type and material as those
sold by GYS.
It is recommended to make some preliminary welding tests if other consumables are used.
Thickness of the support sheet metal (value
To increase or decrease the sheet metal thickness to which the insert will be welded use keys D+ and D-.
If the thickness of the sheet metal is less than that shown on the display, a marking on the rear of the weld may appear.
When the station displays «
an optimal weld.
If this pictogram does not appear, then the maximum sheet metal thickness has been reached. Beyond this thickness,
the welding of the insert is no longer guaranteed.
Power coefficient (value
The Power coefficient is used to adjust the ignition current, the arc energy (current, time) and the attachment current.
Power can be adjusted between -10 and +10. To increase or decrease this coefficient press keys G+ and G-.
Note: Weld synergies are optimized with a default Power coefficient value of 0.
Power Action on the product
• Increase the ignition current
• 2% increase in arc current up to 350A, then
+1 point
3% increase in arc time up to 800ms.
• Increase the attachment current.
• Decrease the ignition current
-1point • 2% reduction of the arc current.
• Decrease of the attachment current."
To change the other synergistic welding parameters (materials, type and size of insert, gas) refer to the chapter «Syner-
gistic Settings».
24
GYSPOT ARCPULL 350
Type, material and size of
insert
Coefficient Power
», the sheet thickness is high enough so that it is not marked on the back while having
)
Goujon M5
Fe ArCO_8%
+1 3.0
zone de
message
)
Influence on the weld
• Better arc ignition on poorly degreased sheet
metal..
• Better ignition in cold weather (<5°C).
• 2% increase of arc energy.
• Reduced risk of sticking during ignition.
• Suitable ignition in hot weather (>35°C).
• 2% decrease of arc energy.
Gas to use
Sheet metal thickness
EN